Titan SF210JSL, Инструкция по безопасности и эксплуатации, Страница: 16 / 28

Note:
• If you see some sparks flashing in the ventilation
slots, do not panic this is normal and will not
damage the machine.
• Be certain the sliding mitre saw is mounted or
placed on a level, firm work surface before using.
A level and firm work surface can reduce the risk
of the sliding mitre saw becoming unstable.
1. RELEASING THE SAW HEAD
When boxed or during storage, transportation,
the saw head is locked in the down position.
To release the head ready for operation apply
downward pressure and pull out the lock pin,
then turn 90° left or right to lock it in place. The
head will be raised gently to upper position. See
Fig8.
2. STARTING THE SAW (Fig9 and 10)
• Push the safety button with your thumb.
• Squeeze the trigger switch.
• Allow the motor to reach full speed.
• When the blade has reached maximum speed,
unlock the blade guard by operating the safety
release lever using your forefinger.
3. CHOP CUT
Chop cut is used mainly for narrow pieces, i.e.
the lock screw of slide rod is tightened and the
head assembly is lowered to cut through the
workpiece.
1. Connect the machine to power outlet ensure
that the mains cable is clear of the blade and base
plate.
2. Position the material to be cut on the rotating
work support table, ensure it is firmly clamped so
that it will not move during cutting.
3. Slide the cutting head to rear position as far as
it will go and lock the slide rod by rotating the lock
screw clockwise. See Fig11.
Ensure that the rotary table lock handle and head
tilt clamp knob are tightened before cutting.
WARNING: Failure to tighten the lock
screw can cause the blade to suddenly
climb up on the top of workpiece and force
itself toward you.
4. Push the safety button and press trigger and
allow the saw blade to run up the speed.
5. Still holding in the trigger, using your forefinger
simply press the safety release lever left. It will
Fig 8
Safety button
Fig 9
Fig 10
Safety release lever
Fig 11
Rotate clockwise
to lock