Titan SF16G, Руководство по эксплуатации

Страница: 5 / 17

16
”
SCROLL SAW SF16G
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR SCROLL
SAWS
1. Never stand on your scroll saw.
Standing on your Scroll Saw or its stand could cause serious injury and damage
to the machine. Do not store materials above or near the tool so that it is
necessary to stand on the tool or its stands to reach them.
2. Check damaged parts.
If any part of the Scroll Saw is damaged, before further use, check carefully that it
will operate properly and perform its intended operation. Any guard or other part
that is damaged should be correctly repaired or replaced.
3. Safe working practices.
Never operate the scroll Saw if taking medication that can cause drowsiness or
when having consumed alcohol or drugs.It is recommended that the Scroll saw
be bolted to a bench with sufficient working space around it.
4. Do not leave the scroll saw running unattended.
Turn off power to machine and unplug mains cable. Do not stop the machine with
work still in contact with the blade.
5. General description
The Scroll Saw is a static indoor machine not suitable for use outdoor. The
machine uses a single-phase alternating current 230V~50Hz motor. Do not
attempt to cut pieces of material too small to hold by hand outside the blade
guard. Avoid awkward hand positions where a sudden slip could cause a hand to
move into the blade.
Avoid the risk of the workpiece jumping upwards, ensure the blade teeth point
downward toward the table.
To avoid blade breakage always adjust blade tension correctly.
6. To avoid losing control of the work piece or tool:
When cutting a large piece of material make sure it is fully supported at table
height. Hold the work piece firmly against the table. Do not force the material
while cutting. Only feed the material fast enough so that the blade maintains a
smooth cutting speed. Use caution when cutting off material which is irregular in
cross section, which could pinch the blade before the cut is completed. A piece of
moulding for example must lay on the table and not be permitted to rock while
being cut. Use caution when cutting off round material such as dowel rods or
tubing . They have a tendency to roll while being cut causing the blade to bite.
Use a Vblock to control the piece. When backing the blade out of the workpiece,
the blade may bind in the kerf (cut) this is usually caused by sawdust clogging up
the kerf. If this happens, turn off the Scroll Saw, remove plug from power source
outlet, wedge open the kerf, and then back the blade out of the workpiece. To
avoid misuse or accidents due to inattention, never leave the scroll saw work area
with the power on or before the machine has come to a complete stop.
Do not perform layout, assembly or set up work on the table while saw is in
operation. Turn the saw off and remove plug from power supply before installing
or removing an accessory or attachment. Never turn your scroll saw on before
clearing the table of all objects (tools scraps of wood etc).
7. Damaged or missing parts.
Should any part of this Scroll Saw be missing, bent or fail in any way or any
electrical component fail to perform properly, shut off the power switch and