Titan SF16G, Руководство по эксплуатации

Страница: 11 / 17

16
”
SCROLL SAW SF16G
OPERATION
Please read and understand the following
guidelines for your scroll saw before
attempting to use it:
There is a skill level associated with using a
Scroll saw. Until you have practiced with the
saw and built up your skill level, be prepared for
the possibility that you might snap the blades.
Following these simple guidelines will help you
achieve best results from your saw:
a) Do not aggressively push wood onto the
blade. Adopt a “feeding” motion and allow
the saw to cut the wood by guiding it onto the
blade. Remember the blade cuts on the down
stroke only.
b) Best results are achieved when cutting wood
less that 25mm thick. When cutting wood thicker
than this feed the wood slowly onto the blade
and be careful not to bend or twist the blade.
c) Replace your blade when it becomes blunt.
d) Be prepared to compensate for the blade
tendency to follow the grain of the wood.
e) As a guide to blade selection very fine narrow
blades should be used to cut in thin wood
(6mm). For wider timber use wider blades.Check
the instructions that come with the blades for
guidance.
f) As a general guide wider blades will not cut
curves as accurate as a narrow blade.
g) Do not apply side pressure to the blade
h) Blades will wear quicker when cutting
plywood or timber over 25mm thick.
Making interior scroll cuts
One of the features of this saw is that it
can be used to make scroll cuts on the interior
of a board without breaking or cutting into the
outline or perimeter of the board.
Warning: To avoid injury from
accidental starting, always turn switch