Titan SF16G, Руководство по эксплуатации

Страница: 13 / 17

16
”
SCROLL SAW SF16G
TROUBLE SHOOTING
Warning:
For your own safety, turn switch “off” and remove the plug before
trouble shooting your scroll saw.
Problem
Breaking blades
Motor will not run
Vibration
Note: There will always
be some vibration
present when the saw is
running because of the
motor operation.
Blades run out.
Blades not in-line with
arm motion.
Problem cause
1.Wrong tension.
2.Over working blade.
3.Wrong blade
application.
4.Twisting blade in
wood.
1.Defective cable or plug.
2.Defective motor.
1.Improper mounting of
saw.
2.Unsuitable mounting
surface.
3.Loose table or table
resting against motor.
4.Loose motor mounting.
1.Blade holders not
aligned.
Remedy suggested
1.Adjust blade tension.
2.Reduce feed rate.
3.Use narrow blades for
cutting thin wood, wide
blades for thicker wood.
4.Avoid side pressure.
1.Replace parts before
using saw again.
2.Consult a service centre.
Any attempt to repair
this motor may create a
HAZARD unless a qualified
service technician does
repair.
1.See mounting
instructions in this manual
for proper mounting
technique.
2.The heavier your
workbench is the less
vibration will occur.
A plywood workbench will
not be as good as solid
timber bench.
Use common sense in
choosing a mounting
surface.
3.Tighten table lock knob.
4.Tighten motor mounting
screws.
1.Loosen cap screws
holding blade holders to
adjust position of blade
holder - retighten holders.