Titan SF1500XP, Инструкция по безопасности и эксплуатации

Страница: 16 / 21

that the clamping is by the hub of the tool and that
the cutting edges are not in contact with each other
or with the clamping elements.
Fastening screws and nuts shall be tightened using
the appropriate spanners, etc., and to the torque
value provided by the manufacturer.
Extension of the spanner or tightening using
hammer blows shall not be permitted.
Clamping surface shall be cleaned to remove dirt,
grease, oil and water.
Clamping screws shall be tightened according to
instructions provided by the manufacturer. Where
instructions are not provided, clamping screws shall
be tightened in sequence from centre outwards.
Use of fixed rings or flanged bushes shall be
permitted if made and fitted to manufacturer
instructions.
ALWAYS WEAR EYE PROTECTION
If excessive vibrations are felt when using the router
STOP IMMEDIATELY. The eccentricity of the router
bit and the clamping system MUST be checked by
competent personnel.
How to Measure Maximum free shank length