Titan 330 Скачать руководство пользователя страница 5

Страница: 5 / 24

12. Unlock the gun by turning the gun trigger lock to the

unlocked position.

Ground the gun by holding it against
the edge of the metal container while
flushing. Failure to do so may lead to
a static electric discharge, which may
cause a fire.

13. Trigger the gun into the metal waste

container.

14. Slowly turn the pressure control knob clockwise to

increase the pressure until fluid starts to come out of the
gun. Use only enough pressure to keep the fluid coming
out.

15. Continue to trigger the gun until the old solvent is gone

and fresh solvent is coming out of the gun.

16. Lock the gun by turning the gun

trigger lock to the locked position.

17. Set down the gun and increase the

pressure by turning the pressure
control knob slowly clockwise.

18. Check the entire system for leaks.

If leaks occur, follow the “Pressure
Relief Procedure” in this manual
before tightening any fittings or hoses.

19. Follow the “Pressure Relief Procedure” in this manual

before changing from solvent to paint.

Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for cleanup.

Painting

1. Place the suction tube into a container of paint.
2. Place the return hose into a metal waste container.
3. Turn the pressure control knob fully counterclockwise to

its lowest pressure setting.

4. Move the PRIME/SPRAY valve down to the PRIME

position.

5. Turn the unit on by moving the ON/OFF switch to the ON

position.

6. Slowly turn the pressure control knob clockwise to

increase the pressure until paint starts to flow out of the
return hose into the metal waste container. Use only
enough pressure to keep the paint coming out.

7. Turn the unit off by moving the ON/OFF switch to the OFF

position.

8. Remove the return hose from the waste container and

place it in its operating position above the container of
paint.

9. Move the PRIME/SPRAY valve up to the SPRAY position.

10. Turn the unit on.

WARNING

Trigger lock

in locked position.

WARNING

11. Unlock the gun by turning the gun trigger lock to the

unlocked position.

Ground the gun by holding it against
the edge of the metal container while
flushing. Failure to do so may lead to
a static electric discharge, which may
cause a fire.

12. Trigger the gun into the metal waste

container until all air and solvent is flushed from the spray
hose and paint is flowing freely. from the gun.

13. Lock the gun by turning the gun

trigger lock to the locked position.

14. Turn the unit off.
15. Attach tip guard and tip to the gun

as instructed by the tip guard or tip
manuals.

POSSIBLE INJECTION HAZARD. Do not spray without the
tip guard in place. Never trigger the gun unless the tip is
in either the spray or the unclog position. Always engage
the gun trigger lock before removing, replacing or
cleaning tip.

16. Turn the unit on.
17. Increase the pressure by turning the pressure control

knob slowly clockwise and test the spray pattern on a
piece of cardboard. Adjust the pressure control knob until
the spray from the gun is completely atomized.

Pressure Relief Procedure

1. Lock the gun by turning the gun

trigger lock to the locked position.

2. Turn the unit off by moving the

ON/OFF switch to the OFF position.

3. Turn the pressure control knob fully

counterclockwise to its lowest
pressure setting.

4. Unlock the gun by turning the gun

trigger lock to the unlocked position.

5. Hold the metal part of the gun firmly to

the side of a metal container to ground
the gun and avoid a build up of static
electricity.

6. Trigger the gun to remove any