Titan 155FLAIL, Руководство оператора

Страница: 15 / 24

15
V-BELT INSTALLATION
1. Remove belt cover and loose gearbox mounting bracket bolts as well as adjusting bracket
bolts.
2. Loose tension bolt and nut to disengage belt tension until belt can be removed.
3. Replace new belt and turn the tension bolt until desired tension is achieved. Retighten
tension nut and then retighten tension plate bolts, last retighten gearbox mounting bolts.
When the belt has the correct tension, the gearbox should be adjusted so that the
gearbox extension is running straight (parallel) with the flail mower.
4. Re-install pulley cover.
STORAGE
At the end of the working season or when the mower will not be used for a long period. It is
good practice to clean off any dirt or grease that may have accumulated on the mower and any
of moving parts.
1. Cleaning necessary.
2. Check blades for wear and replace if necessary.
3. Inspect mower for loose, damaged, or worn parts and adjust or replace as needed.
4. Store unit inside, if possible, for longer life.
5. Repaint parts where paint is worn or scratched to prevent rust.
GEARBOX
GEARBOX
Type of lubrication: SAE EP 90W Gear Oil. Check oil
level through cap for gearbox oil level.
DO NOT OVERFILL!
WARNING: OVERFILLING OR UNDERFILLING
gear oil may gearbox cause gearbox seizing or
damage and driveline shaft twisting
.
Check oil level in gearbox by removing the cap located on the right-hand side. Oil should be
level with middle side of plug hole, add oil, if necessary, by removing top cap and side plug. Add
oil until it flows om middle side plug hole.