Titan 155FLAIL, Руководство оператора

Страница: 12 / 24

12
10. Mower blades will cut better at a faster blade speed than at reduced throttle.
11. After mowing the first 50 feet, stop and check to see that the mower is adjusted correctly.
12. Do not make sharp turns or attempt to back up while the mower is on the ground.
13. Do not engage PTO with the mower in the fully raised position. Do not engage PTO at full
throttle.
14. Do not allow anyone, including yourself, near the mower when it is operating.
15. Periodically check for foreign objects wrapped around the rotor shaft and remove them
after disengaging PTO, turning off the tractor, and removing the ignition key.
SECTION 3: ADJUSTMENTS
LEVELING THE MOWER
NOTE: Tractor and mower should be on level ground. Leveling can be adjusted at the tractor
draw bars
1. Park tractor and mower on a level ground.
2. Slowly raise mower by tractor draw bars until it is about 1” to 2” above the ground.
3. Ensure that the lower draw bars are stabilized to prevent excessive side movement.
4. Place a level on the top of the mower deck from left to right and adjust one of the tractors
lower draw bars up or down until the mower is level from left to right.
5. Adjust tractor’s upper draw bar to place the upper hitch pin vertically above or slightly
behind the lower hitch pins.
6. Slowly operate the tractor draw bars up and down to check for clearance between the
tires, frame, drawbar, etc.
CUTTING HEIGHT ADJUSTMENT
NOTE: Before first operation, ensure roller weldment is adjusted to proper setting.
1. The machines cutting height depends upon the position of the rear roller.
2. Remove the bolts that fix the roller on both sides.
3. Lift or lower both sides of roller in equal measurements.
4. Replace bolts and retighten.