Titan Tool 1140ix Скачать руководство пользователя страница 4

Страница: 4 / 24

General Description

This airless sprayer is a precision power tool used for spraying
many types of materials. Read and follow this instruction
manual carefully for proper operating instructions,
maintenance, and safety information.

Operation

This equipment produces a fluid stream at extremely high
pressure. Read and understand the warnings in the
Safety Precautions section at the front of this manual
before operating this equipment.

Setup

Perform the following procedure before plugging in the power
cord of an electric unit.

1. Ensure that the siphon tube/siphon set and the return

hose are attached and secure.

2. Using a wrench, attach a minimum of 50’ of nylon airless

spray hose to the unit. Tighten securely.

3. Attach an airless spray gun to the spray hose. Using two

wrenches (one on the gun and one on the hose), tighten
securely.

Make sure all airless hoses and spray guns are electrically
grounded and rated for at least 3300 psi (220 bar) fluid
pressure.

4. Make sure the pressure control knob is in its OFF position

in the black zone.

5. Fill the wet cup with one tablespoon of piston seal

lubricant (Piston Lube).

Never operate unit for more than ten seconds without
fluid. Operating this unit without fluid will cause
unnecessary wear to the packings.

6. Make sure the electrical service is 120V, 15 amp

minimum.

7. Plug the power cord into a properly grounded outlet at

least 25’ from the spray area.

CAUTION

WARNING

NOTE: Do not attach the tip to the spray gun yet.

Remove the tip if it is already attached.

WARNING

Return

Hose

Siphon

Tube

Pressure

Control

Knob

Electronic

Pressure

Control

Indicators

Circuit

Breaker

Fluid

Section

Filter

Motor

PRIME/

SPRAY

Valve

Outlet

Fitting

Always use a minimum 12 gauge, three-wire extension
cord with a grounded plug. Never remove the third prong
or use an adapter.

Preparing a New Sprayer

If this unit is new, it is shipped with test fluid in the fluid section
to prevent corrosion during shipment and storage. This fluid
must be thoroughly cleaned out of the system with mineral
spirits before you begin spraying.

Always keep the trigger lock on the spray gun in the
locked position while preparing the system.

1. Place the siphon tube into a container of mineral spirits.
2. Place the return hose into a metal waste container.
3. Move the PRIME/SPRAY valve down to the PRIME

position.

4. Turn the unit on and set the pressure to minimum by

turning the pressure control knob to the “Min PSI” setting
in the yellow zone.

5. Allow the sprayer to run for 15–30 seconds to flush the

test fluid out through the return hose and into the waste
container.

6. Turn the unit off by moving the pressure control knob to

the OFF position in the black zone.

Preparing to Paint

Before painting, it is important to make sure that the fluid in the
system is compatible with the paint that is going to be used.

Always keep the trigger lock on the spray gun in the
locked position while preparing the system.

1. Place the siphon tube into a container of the appropriate

solvent. Examples of the appropriate solvent are water for
latex paint or mineral spirits for oil-based paints.