Tisira TGF30G, Руководство пользователя, Страница: 13 / 20

pg 13 tisira | www.tisira.com
InsTallaTIOn
1200mm long. The hose must not be kinked or be able to touch any hot surface. The supply
connection point must be accessible when installed.
GAS LEAKAGE AND OPERATION CHECK
The appliance must be tested by the installer before leaving. Check all burner flames are
blue in colour, stable and completely ignite at both high and low flame settings with no
appreciable yellow tipping, carbon deposition, lifting, floatinglighting back or objectionable
odour. Test burners individually and in combination.
ELECTRICAL CONNECTION
The cooktops fitted with a tripolar electrical supply cord are designed to be be used with
alternating current according to the indications on the rating plate located under the cooktop.
The earth wire can be identified by its yellow-green colour. In the case of installation over a built-
in electric oven, the electrical connections for the cooktop and oven should be independent, not
only for safety purposes, but also to facilitate removal of one or both in the future.
ELECTRICAL CONNECTION FOR GAS COOKTOP
The supply cord has been fitted with a 10A 3 pin plug. The power supply cord must be positioned
so that it does not reach a temperature in excess of 50degC above room temperature at any
point.
before actual connection make sure that:
The fuse and electrical system can withstand the load required by the appliance;
That the electrical supply system is equipped with an efficient earth hook-up according
to the norms and regulations prescribed by law;
That the plug and switch are easily accessible after installation.
Important //
the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow - Earth
blue
- Neutral
brown - Live
As the colours of the wires in the mains lead may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows: Connect the Green & Yellow wire
to terminal marked “E” or coloured Green or Green & Yellow.
Connect the brown wire to the terminal marked “L” or coloured Red.
Connect the blue wire to the terminal marked “N” or coloured black.