Tisira TGF30G, Руководство пользователя, Страница: 11 / 20

pg 11 tisira | www.tisira.com
C Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e.g.
opening a window or increasing the power of the air intake system (if present).
D Liquefied petroleum gases are heavier than air and, as
a result, settle downwards. Rooms in which LPG tanks
are installed must be fitted with ventilation openings
to the outside in order to allow the gas to escape in the
event of a leak. Therefore, LPG tanks, whether empty or
partially full, must not be installed or stored in rooms
or spaces below ground level’ (cellars, etc.). It is also
a good idea to keep only the tank currently being used
in the room, making sure that it is not near sources of
heat (ovens, fireplaces, stoves, etc.) that could raise
the internal temperature of the tank above 50ºC.
E Overhead clearances—(Measurement A) Rangehoods and exhaust fans shall be installed
in accordance with the manufacturer’s relevant instructions. However, in no case shall
the clearance between the highest part of the hob of the gas cooking appliance and a
range hood be less than 600 mm or, for an overhead exhaust fan, 750 mm.
Side clearances—(Measurements b, & C) Where b, measured from the periphery of
the nearest burner to any vertical combustible surface, or vertical combustible surface
covered with toughened glass or sheet metal, is less than 200 mm, the surface shall
be protected to a height C of not less than 150 mm above the hob for the full dimension
(width or depth) of the cooking surface area. Where the gas cooking appliance is fitted
with a ‘splashback’, protection of the rear wall is not required.
F In the event the cooktop is not installed above a built-in oven, a wood panel must be
inserted as insulation. This panel must be placed at least 30 mm from the bottom of the
cooktop itself.
IMPORTANT // When installing the hob above a built-in oven, the oven should be placed on
two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at
least 45 x 560 mm at the back.
InsTallaTIOn