Tisira TDW12X, Руководство пользователя

Страница: 19 / 24

pg 19 tisira | www.tisira.com
INSTALLATION
ELECTRICAL CONNECTION
NOTICE // During installation, the power
supply must not be excessively or dangerously
bent or flattened.
Before inserting the plug into the electrical
socket, make sure that:
• the socket is earthed and complies with
current regulations;
• the socket can withstand the maximum
load of the appliance, which is indicated
on the data plate located on the inside of
the door(see description of the appliance);
• the power supply voltage falls within the
values indicated on the data plate on the
inside of the door;
•
the socket is compatible with the plug of
the appliance. If this is not the case, ask an
authorised technician to replace the plug
(seek assistance); do not use extension
cables or multiple sockets.
•
Once the appliance has been installed,
the power supply cable and the electrical
socket should be easily accessible.
• The cable should not be bent or compressed.
• If the power supply cable is damaged, it
must be replaced by the manufacturer or
its Technical Assistance Service in order
to prevent all potential hazards.
•
The company shall not be held responsible
for any incidents that occur if these
regulations are not observed.
HOW TO DRAIN EXCESS WATER
FROM HOSES
If the sink is 1000mm higher from the floor,
the excess water in hoses cannot be drained
directly into the sink. It will be necessary to
drain excess water from hoses into a bowl
or a suitable container that is held outside
and lower than the sink.
SYPHON CONNECTION
The waste connection must be at a height
of between 50cm (minimum) and 100cm
(maximum) from the bottom of the dish. The
water drain hose should be fixed by a hose clip.
STARTING YOUR DISHWASHER
The followings should be checked before
starting the dishwasher:
1. Whether the dishwasher is level and fixed
2. Whether the inlet valve is opened
3. Whether there is leakage at the
connections of the conducts
4. Whether the wires are tightly connected
5. Whether the power is switched on
6. Whether the inlet and drain hoses are knotted
7. All packing materials and printings
should be taken out from the dishwasher
NOTICE // After installation, please put this
manual into the bags of printings. The content
of this manual is very helpful to the users.
NOTICE // Other means for disconnection
from the supply must be incorporated in
the fixed wiring with at least 3mm contact
separation in all poles.
m
ax
11
00
m
m
m
in
50
0m
m
m
in
12
0m
m
min 40mm