background image

Timpdon Marine

 

Tel    0161 - 980 8054 

Issue 1 – May 2011

 

Web

 

www.timpdon.co.uk

  

 

EMail  [email protected]  

Programming 

 

Programming or re-programming may be performed at any time, using 

push button switches 

S1

 and 

S2

, with indication provided by the 

LED.

  

 

Programming is performed in three steps, in order – 

Servo Reset 

Position, Servo Set Position

 and 

Servo Rotation Rate 

 

The 

set

 and 

reset

 limit positions of the servo may be set anywhere within 

its operating range, subject to a limitation of RC pulse widths of 0.6 ms to 

2.4 ms, as described above . 

 

 
Programming Procedure 
 

 

Programming may be undertaken with the transmitter either on or off. 

 

 

Press and hold both switches 

S1

 and 

S2

 together. 

 

The 

LED

 will flash rapidly for about 5 seconds, and then go on 

continuously.  Then release both switches. 

 

 

If you release either switch before the LED stops flashing, the unit 

will remain in normal operation. 

 

You are now in 

Step 1 – Servo Reset Position 

 

The 

LED

 will flash with 

single short

 flashes, and the servo will move to 

the current 

reset

 position. 

 

 

Adjust the required 

reset

 position using either 

S1

 to increase the servo 

position or 

S2

 to decrease it. The actual rotation direction is servo 

dependent. 

 

 

When satisfied, press and hold both switches 

S1

 and 

S2

 together. 

 

The 

LED

 will flash rapidly for about 2 seconds, and then go on 

continuously.  Then release both switches. 

 

 

If you release either switch before the LED stops flashing, the unit 

will remain in program Step 1.

 

 
 

The unit will then proceed automatically proceed to program 

Step 2

Отзывы: