Timpdon Marine
Tel 0161 - 980 8054
Issue 1 – May 2011
Web
www.timpdon.co.uk
EMail [email protected]
Installation and Wiring
S2
S1
LED
V+
Control
0V
Red
Yellow
Black
Connector to Servo
MRSS2
Connector to
Radio Receiver
1
Connect the flying lead to the selected channel of your radio receiver.
2
Connect your servo to the 3 pin plug on the
MRSS2
, with the black servo
lead adjacent to edge of unit, and the yellow or white data lead towards
the middle.
3
Power up the transmitter. Then power up the receiver.
4
Check that, once the receiver has bound to the transmitter, the
LED
on
the
MRSS2
illuminates continuously. This indicates that the
MRSS2
is
receiving valid RC pulses. The
MRSS2
has a in-built start up delay of 4.5
seconds to permit binding. During this period, the
LED
will flash.
5
Check that, when you set the joystick to
maximum
, the servo rotates at
a controlled rate towards the
set
position, when you set the joystick to
minimum
, the servo rotates back towards the
reset
position, and when
you set the joystick to the
centre neutral
position, servo rotation
stops
.
6
If, at any time, radio communication is lost, the
LED
will extinguish and
servo rotation will stop. Once communication is re-established, normal
operation will start again automatically.
7
Now program the
MRSS2
, as described below, for the required servo end
limit positions and rotation rate for your system.
On completion of programming, the programmed settings will be saved in
non-volatile memory, and the system will automatically re-boot in normal
operation mode.
8
Your system is now ready for use.
