User Manual-JP4
Version C May 2020
13 of 20
13
2.3.3 Two limit switches to cut the current and an additional limit switch for
signal output
The actuator is equipped with two limit switches to cut the current of the motor when the actuator moves to
the end of each stroke, and an additional limit switch sends out the signal at specific stroke positions.
Wire
AWG
Description
Spec
Yellow 20
Connect to Vm+ to extend the actuator.
Connect to Vm- to retract the actuator.
24V version: Input voltage 18~32 V DC.
12V version: Input voltage 9~16 V DC.
Green 20
Connect to Vm- to extend the actuator.
Connect to Vm+ to retract the actuator.
White
26
Connect to common pin (C.)
The signal is potential free and independent
from the motor power circuit.
The signal is short circuit when the actuator
moves to the position where the middle
limit switch is triggered.
The middle limit switch is installed at the
position upon customer’s request and
physically preset in factory which is not
adjustable. The middle limit switch, installed
in position by customer request, is factory
preset and non-adjustable.
Connect the middle limit switch signal with
max 32V, <1A.
Black
26
Connect to normal closed pin (N.C.)
Yellow
Green
Red
Black
