TimeLink TLR401, Руководство пользователя

Страница: 13 / 29

TLR401 Administration
13
4.4 User Operation
4.4.1 Authentication, TLR401:
Authorized users who's fingers have been enrolled and who's PIN have been registered are
granted access when entering:
Finger without PIN: Press => Bio-Sensor is illuminated
Apply Finger => Green LEDs (Access granted)
Finger plus PIN: Press => Bio-Sensor is illuminated
(Wiegand) Apply Finger => LEDs flash (Waiting for PIN entry)
Enter PIN => Green LEDs (Access granted)
Finger plus PIN: Press => Green and Red LEDs 1 and 4 flash (Waiting for PIN entry)
(RS485) Enter PIN => Bio-Sensor is illuminated
Apply Finger => Green LEDs (Access granted)
4.4.2 Authentication, TLR401-iCLASS:
Authorized users who's fingers have been enrolled and who's iClass cards and PIN have been
registered on the access controller are granted access when entering:
Finger: as above
Card without PIN: iCLASS card => Beep and short green signal (Indication card was read)
=> Green LEDs (Access granted)
Card plus PIN: iCLASS card => Beep and short green signal (Indication card was read)
(Wiegand) => LEDs flash (Waiting for PIN entry)
Enter PIN => Green LEDs (Access granted)
Card plus PIN: iCLASS card => Beep and short green signal (LEDs 2/3) (Indication card was read)
(RS485) => Green and Red LEDs 1 and 4 flash (Waiting for PIN entry)
Enter PIN => Green LEDs (Access granted)
4.4.3 Authentication, 'Template on Card' (TLR401-iCLASS only)
Authorized users who's fingers have been stored onto their card and who's iCLASS cards and PIN
have been registered on the access controller are granted access when entering:
Card without PIN: iCLASS card => LEDs flash green.
Beep when finished reading the card (Indication card was read)
=> Green LEDs
(Access granted)
Card plus PIN: iCLASS card => LEDs flash green.
Beep when finished reading the card (Indication card was read)
=> LEDs flash
(Waiting for PIN entry)
Enter PIN => Green LEDs (Access granted)
The TLR401-iCLASS reads fingers and iCLASS cards alternatively without having to switch
between operating modes.
If a mistype occurs on the keypad simply press the “#” three times to reset and start over.
The various operating modes are configured in the administrator’s menu as described in section 5.