4
5.5 Attach the strain relief to the luminaire
and screw in ensuring not to over-tighten.
5.6 Terminate the supply cable into the terminal
block (please refer to section 6 connection
diagram) ensuring correct polarity is observed
and that all bare conductors are sleeved.
5.7 Attach the supplied wall plate to the
luminaire, apply pressure to catches located
on top and bottom until all click into place to
ensure the weatherproof seal.
5.8 Attach the luminaire to the U bracket
fitted to the wall, then screw in on both
sides ensuring not to over-tighten.
5.4 Secure the supply cable into
the junction box through the
hole(s) provided ensuring that a
cable gland, grommet or sealing
compound is used to maintain
the IP rating of the luminaire.
