General:
• Ensure appropriate fixings are used for mounting surface.
• This product is not suitable for installation in or near a coastal or marine environment.
Cleaning:
• Do not use any chemical or abrasive cleaners.
• Clean product with only a soft dry cloth.
Warning:
• This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
Recycling Advice:
Waste Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Full Technical specification available upon request. Contact [email protected] for PDF.
Secure PIR LED Security Light
Sensor Operation Instructions:
1)
Remove the dial cover on the rear of the sensor to
access the sensor controls. (see Fig.4)
•
Dial 1 controls the desired lux level. Turn fully
anti-clockwise to the moon icon to select night
mode. Turn fully clockwise to select day mode.
• Dial 2 controls the time. Turn fully clockwise for
the maximum 10 minutes or anti-clockwise for the
minimum of 10 seconds.
• Dial 3 controls the detection range. Turn fully
anti-clockwise for the minimum range of 4m. Turn
clockwise for the maximum range of 8m (based on
a mounting height of 2.5m)
Manual Override:
To operate the manual override function when light is
on, switch OFF, ON, OFF, ON within the 3 seconds for
the light to stay on.
