Timberwolf TW 280FTR (Petrol), Инструкция по эксплуатации

Страница: 62 / 68

8.4 6-Monthly Storage Checks
1. Refer to Section 8.3 " 3-Monthly Storage Checks" on page 59, and complete all the
checks.
2. Clean and drain all lubrication lines, including grease pipes, fuel lines, coolant and oil
reservoirs. Replace with new lubricants.
3. Remove old grease from the track tension adjuster unit, refill with fresh grease and
reset track tension. (Section 5.19.3 " Adjusting Track Tension" on page 52.)
8.5 12-Monthly Storage Checks
1. Refer to Section 8.4 "
6-Monthly Storage Checks" on page 60, and complete all the
checks.
2. Inspect the bearing lubrication system for the presence of water. If water is detected,
flush out the bearing housing and re-lubricate immediately.
8.6 Recommissioning after Storage
1. Ensure the chipper is stable.
2. Remove all guards and check all fasteners. ( Section 5.7 " Check and Replace
Fasteners" on page 40.)
3. Ensure the discharge tube is greased ( Section 5.14 " Grease the Discharge Tube
Mounting Flanges" on page 47), fastened, free of blockages, rotates through its full
range of movement and cannot face the operators working position.
4. Ensure the feed funnel is free from foreign objects (e.g. tools or clothing).
5. Open and close the feed tray to ensure it operates correctly.
6. Check fuel, engine oil and hydraulic fluid levels and top up as required. *
7. Inspect all internal parts (e.g. drive belts, taper locks and shaft key-ways).
8. Check belt tension. (Section 5.9 " Adjust Rotor Drive Belt Tension" on page 43 and
Section 5.10 "
Adjust Hydraulic Pump Drive Belt Tension" on page 43.)
9. Inspect the cutting blades to ensure they are sharp and suitable for use.
10. Refit all guards.
Before reconnecting the battery cables ensure that the machine is in a well-ventilated
area and that any fuel fumes have been allowed to dissipat.
11. Connect the battery cables. (Section 5.6 " Battery Safety Information" on page 38.)
12. Carry out an electrical diagnostic continuity check, to ensure the circuit is complete.
13. Lubricate all grease pipes. Remove pipes and bleed the system prior to use, if
necessary. *
14. Check the condition of the rubber tracks. ( Section 5.19.2 " Checking the Rubber
Tracks" on page 51.)
15. Remove old grease from the track tension adjuster unit, refill with fresh grease and
reset track tension. (Section 5.19.3 "
Adjusting Track Tension" on page 52.)
60/66 C190-0308 - Rev 1.0 EN
TW 280FTR (Petrol) 8 Storage