SERVICE INSTRUCTIONS
17
GREASE THE TOP ROLLER SLIDE
NOTE: This should be done every 50 hours. In dirty or dusty conditions or during periods of
hard work it should be done more frequently. If the slides become dry the top roller will tend
to hang up and the pulling-in power of the rollers will be much reduced. Excessive wear will
ensue.
fig 16.
ENGINE MANUFACTURER’S HANDBOOK
1
Refer to your Engine Manufacturer’s Handbook for detailed instructions on the following:
GREASING ROTOR BEARINGS
Both front and rear bearings are sealed and do not need greasing.
2
Changing the fuel filter
Checking the engine oil
Changing the engine oil
Changing the engine oil filter
GREASE THE JACK STAND
The jack stand requires intermittent greasing to maintain a smooth operation.
1.
Brush off dirt with a stiff brush.
2.
Apply grease liberally to screw thread using a brush.
3.
Wind mechanism up and down a couple of times to ensure grease has covered all surfaces.
1.
Remove the near side roller box guard.
2.
Open the rotor housing.
3.
Apply multipurpose grease directly to the slide
surfaces indicated.
4.
Close the rotor housing.
5.
Re fit the near side roller box guard.
GREASE THE ROLLER DRIVE AND BEARING
1.
Open the rotor housing.
2.
Locate the two grease nipples indicated.
3.
Apply multi purpose grease liberally using a
grease gun.
4.
Close the rotor housing.
2
3
3
fig 17.
GREASE THE DISCHARGE FLANGE
fig 18.
1.
Remove the discharge tube.
2.
Apply multipurpose grease to surface shown.
3.
Refit discharge tube.
2
