Timberk DH TIM 30 E9, Инструкция по эксплуатации

Страница: 6 / 32

www.timberk.com • Electric drier for changing of air humidity
6
Indicator lights
When you push the button to change operation modes, the unit will make
a beep sound to indicate that it is changing modes.
1. COMFORT Pad (optional)
Press to activate the comfort dehumidifying operation.
2. FILTER Pad
The check filter feature is a reminder to clean the Air Filter for more
efficient operation. The Filter light(Clean filter l ight) will illuminate after
250 hours of operation. To reset after cleaning the filter, press the Filter
pad and the light will go off.
3. CONTINUE Pad
Press to activate the continuous dehumidifying operation.
4. TURBO Pad
Control the fan speed. Press to select either High or Normal fan speed.
Set the fan control to High for maximum moisture removal. When the
humidity has been reduced and quiet operation is preferred, set the fan
control to Normal.
5. Timer Pad
Press to initiate the Auto start and Auto stop feature, in conjuction with
the and key pads.
NOTE:
On this operation,the unit can not be set humidity level.
6. « » / « »: Up/Down Pads
• Humidity Set Control Pads
The humidity level can be set within a range of 35%RH(Relative Humidity)
to 85%RH(Relative Humidity) in 5% increments.
For drier air, press the
« » pad and set to a lower percent value(%).
For damper air, press the « » pad and set a higher percent value(%).
• TIMER Set Control Pads
Use the Up/Down pads to set the Auto start and Auto stop time from
0.0 to 24.
7. Power Pad
Press to turn the dehumidifier on and off.
8. Display
Shows the set % humidity level from 35% to 85% or auto start/stop
time (0~24) while setting, then shows the actual ( ± 5% accuracy) room
% humidity level in a range of RH(Relative Humidity) to 90%RH(Relative
Humidity).
Error Codes and Protection Code:
AS- Humidity sensor error – Unplug the unit and plug it back in. If error
repeats, call for service.
ES- Tube Temperature sensor of the evaporator error-- Unplug the unit
and plug it back in. If error repeats, call for service.
P2- Bucket is full or bucket is not in right position-- Empty the bucket
and replace it in the right position.(only available for the uint with no
pump feature.)
P2- Bucket is full – Empty the bucket.(only available for the unit with
pump feature.) 30%
EC- Refrigerant leakage detection – With this new technology, the
display area will appear EC when the unit detects refrigerant leakage
,call for service.
E3- Unit malfunction – Unplug the unit and plug it back in. If error
repeats, call for service.
Eb- Bucket is removed or not in right position-- Replace the bucket in
the right position.(only available for the unit with pump feature.)
Fig. 5.