Timberk DH TIM 30 E9, Инструкция по эксплуатации

Страница: 4 / 32

www.timberk.com • Electric drier for changing of air humidity
4
4. APPLIANCE DESCRIPTION
1. Control panel
2. Panel
3. Water bucket
4. Water level window
5. Handle (both sides)
1. Continuous drain hose outlet
2. Caster
3. Power Cord and plug
4. Power cord buckle (placed in
the water bucket, used only when
storing the unit. Installed as shown
Fig.3a))
5. Pump drain hose outlet(some
models without)
6. Air outlet grille
7. Air filter
Front Rear
Fig. 1.
Fig. 2.
Fig. 4.
Fig. 3.
Positioning the unit
A dehumidifier operating in a basement will have little or no effect in
drying an adjacent enclosed storage area, such as a closet, unless here is
adequate circulation of air in and out of the area.
• Do not use outdoors.
• This dehumidifer is intended for indoor residential applications only. This
dehumidifier should not be used for commercial or industrial applications.
• Place the dehumidifier on a smooth, level floor strong enough to support
the unit with a full bucket of water.
• Allow at least 20cm of air space on all sides of the unit for good air
circulation.
• Place the unit in an area where the temperature will not fall below
5
O
C(41
O
F). The coils can become covered with frost at temperatures below
5 O C(41 O F), which may reduce performance.
• Place the unit away from the clothes dryer, heater or radiator.
• Use the unit to prevent moisture damage anywhere books or valuables
are stored.
Accessories:(placed in the water bucket of the unit)
Identification of parts
NOTE:
All the pictures in the manual are for explanation
purposes only.Your unit may be slightly different.The
actual shape shall prevail.The operations and functions
are the same.