IM2021
19
Table 2
Malfunction
Possible cause
Solution
The device is connected
to the mains, operating
mode is set to heating but
device isn’t working.
No power
Check whether the power
supply
is
disconnected
from
the
device
and,
if
necessary,
connect device to power
supply
Electrical circuit of heating
element malfunction
Contact
an
authorized
service center
Malfunction
in
circuit
breaker
Change the circuit breaker
Defective thermostat
Contact an
authorized service center
Defective heating element
Faulty temperature limiter
Power cord is broken
Contact an
authorized service center
to fix it
Heating
is
not
good
enough
Low voltage in
power network
Check power network
Low heating temperature
is set on thermostat
Set the temperature higher
on thermostat
Defective heating element
Contact
an
authorized
service center
11. STORAGE
Make sure that the appliance body and its heating element have cooled down before
the appliance is dismantled and packed in its packaging for long-term storage.
Complete all requirements of chapter CLEAN AND CARE.
Reel on the power cord.
When the device is not in use for a long time, store it in a cool, dry place in the original
cardboard box.
12. UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in compliance with
the laws, rules and methods in region of recycling. Detailed information about
the recycling of the device, you can receive from a representative of the local
authorities, after providing full information about the device. The manufacturer
and authorized organization of the manufacturer do not carry responsibility for
the fulfillment by the Buyer of the requirements of legislation on utilization and methods
of utilization of the device selected by the Buyer. The lifetime of the device is indicated
in the warranty card. Warranty period for the device and warranty terms are specified
in the warranty card. The warranty card is an integral part of the documentation
supplied with this unit. If there is no warranty card in the delivery set, ask for it from the
Seller. The warranty card provided by the Seller must conform to the manufacturer’s
form.
The manufacturer and the authorized organization of the manufacturer remove
responsibility for any possible harm which can be caused to people, animals or
property directly or indirectly, if this harm occurred as a result of noncompliance with
the rules and operating conditions, installation of the device, intentional or reckless
actions of the user- and / or third parties, as well as in situations caused by natural and
/ or anthropogenic accidents.
Содержание Blanco Ext Series
Страница 40: ...www timberk ru ...