Timberk Blanco Ext Series, Инструкция по эксплуатации

Страница: 18 / 40

IM2021
18
6. During the first minutes of radiator’s operation you may fell a slight smell of burning.
It may be caused by dust on the unit; it will soon disappear. If necessary, you can
clean the unit, fol
lowing rules in this manual and observing «Safeguards».
7. When the room temperature will reach the desired level, you should slowly turn the
thermostat knob counterclockwise (towards MIN). You will hear a click of the
thermostat turning off, and the light on the control panel will go out. Now the room
temperature will be maintained at the chosen level.
8. If you need to reduce the room temperature, turn the thermostat knob
counterclockwise. Also you can lower the unit’s heating power (I or II).
9. If you need to increase the room temperature, turn the thermostat knob clockwise
(maximum possible position is MAX). Also you can increase the unit’s heating power (II
or III).
IMPORTANT!
For the correct operation of the unit, the level of voltage in electric mains must be
sufficient in strict compliance with the technical parameters indicated on the unit. See
the technical label, as well as all labels with special warnings, attached to the unit.
9. CLEANING AND MAINTENANCE OF THE UNIT
1. Remember that you must clean the unit regularly to remove dust from the heating
sections. Dust and dirt on the unit have a negative effect on the unit’s operational
efficiency. In some cases a smell of burning dust can cause a headache and nausea,
as well as other negative health effects. Also a dirty unit cannot operate 100%
effectively, temperature parameters of the room heating can be disrupted.
2. Before cleaning of the unit, you must switch off the unit, unplug it from electric mains
(see «Safeguards») and let the unit cool down.
3. Clean the unit’s sections and other surfaces with a soft, slightly damp duster/cloth.
The cloth must not leave fluff on the unit.
4. It is not recommended to use detergents, including liquids/materials containing
abrasive elements.
5. During cleaning, please, do not damage the unit with sharp objects (hard sponge,
polishing paper, etc). Scratches on the painted surface can result in rusting.
6. Switch on and use the unit again only after reading all «Safeguards»; also make
sure that the unit is absolutely dry.
NOTE:
The color change of the sections is not a defect, but is a consequence of the operation
of the device in a room with heavily polluted air.
10. TROUBLESHOOTING
Possible malfunctions and solutions for them are indicated in table 2.
If it is impossible to solve these malfunctions with these methods, contact the
authorized service center.