D-Box User's Manual
English
6 / 64
tiko Energy Solutions AG
IM-0007-0006 Rev. 5
Installing the D-Box
Step 1
Remove power
from the electrical panel.
Step 2
Unhook the heater
from its holder and put it to the side.
Step 3
Cut the existing cable that leads from wall to the heater. If you own the
Kit K03-CDK-01.1014-01-P1, the socket is already equipped with wires
on one side. In this case, do not cut the wires, but unscrew them from
the heater.
Prepare the wires
where necessary by crimping bootlace fer-
rules.
Step 4
Remove the cover from the socket. If you hold the socket like displayed
in
IMAGE 7
, clamp the
phase
coming from the wall/source into the top
terminal, and the phase going to the heater into the bottom terminal.
Step 5
Clamp the
neutral
wire coming from the wall/source and going to the
heater into the middle terminal. There is space on both sides of the
screw for two wires.
Step 6
If your heater supports
Fil Pilote
: hold the socket as displayed in
IM-
AGE 7
, clamp the Fil Pilote coming from the wall/source into upper mid-
dle terminal and the Fil Pilote going to the heater into the lower middle
terminal. A proper wiring is displayed in
IMAGE 8
.
Step 7
Fasten the strain relief to prevent the wires in the terminal from being
pulled out.
Tighten again all clamp screws with enough torque. Insuffi-
cient clamping force can result in high contact resistance
that leads to device heating and can result in a fire hazard.
Step 8
Put back the cover of the socket.
Step 9
Engage the D-Box and the socket
as displayed in
IMAGE 9
: Push the
two levers of the socket in order to open the safety shutter and plug in
the D-Box.
