13 |
P a g e
Tigo Energy, Inc.
|
www.tigoenergy.com
|
Mounting the EI ATS
Tools needed: Electric drill, 8mm bit hammer/mallet, level, pencil, socket wrench
Accessory parts needed: Sleeve anchors (
C
), mounting bracket (
H
), ATS (
A
)
Warning!
Before drilling into the wall, inspect for existing electrical or plumbing installations
to avoid electric shock or other injury.
Note
The instructions below are for securing the enclosure to drywall. If another surface
is used, use appropriate hardware to securely mount the ATS.
1)
Use a level and the mounting bracket (
H
) to mark the
mounting holes. Drill out mounting holes to 1.6”
(40mm) depth. Place the sleeve anchor (
C
) in each
hole, tap with the mallet/hammer. Place mounting
bracket aligned with the anchors exposed through the
screw holes and use the 3 mounting screws to attach
to the wall.
2)
Confirm bracket is level and screws are tight then lift ATS on to
the mounting bracket.
Figure 10 Mounting bracket
Figure 11 Mounting the ATS
