TigerStop TigerSaw Miter, Руководство пользователя

Страница: 10 / 52

4
System Power
Saw Control Panel
Power into the TigerSaw Miter system is turned on and off with the large red rotary
switch on the power cabinet, located at the right rear corner of the saw base. In the
off position, this switch folds out and can be locked into place for lockout/tagout
procedures.
A saw cycle can also be triggered by the foot pedal on the front of the saw base (right)
or within an automated list in the TigerTouch software ( pg. 22 ).
This panel, located on the front left corner of the saw base, allows direct control of
basic saw functions.
The power switch, on the bottom left, toggles power to the saw control circuitry. The
power lamp, in the upper left, shows when power is on.
The green button turns the saw motor on, spinning the blade. The green button will
glow while the saw motor is active.
The red button turns the saw motor off.
• The blade will continue spinning for some time after the motor has been turned off.
The yellow button starts a saw cycle.
During a saw cycle:
The top cap fires.
The saw strokes and returns to the base.
The top cap releases.
• The pusher position and the miter angle cannot be changed while the saw cycles.
Saw Operation