Tiger WILDCAT JD6105D, Монтаж и эксплуатация

Страница: 51 / 252

ASSEMBLY
Assembly Section 2-19
REAR STOW SIDE FLAIL HOSE ROUTING
WARNING NOTE:
The sudden release of hydraulic pressure could cause the sudden
movement of very heavy parts. Anyone in the way of these parts could be severely hurt or killed.
In order to prevent hydraulic failure, DO NOT ALLOW these hydraulic hoses to BREAK or
BURST. Make sure the hoses do not pinch or stretch as boom moves. Measure TWICE, check
TWICE, then proceed with caution.
Route the hoses from the flail motor through the space between the slider assembly and the
flail deck as shown above. Clamp the hoses with hose clamp P/N 35131, but do not tighten at
this time. Next, route the hoses from the hose clamp through the hose ring and attach them to
the boom hoses. Before tightening the hose clamp, make sure the hoses do not pinch, stretch or
rub on any edges when the flail head moves through its articulation and sliding. Finally, attach
the hose cover P/N 06505020 between the hose clamp and the hose ring. Refer to the Parts
Section for hardware.
(ASM-RSS HOSE ROUTING-0002)