Tiger WILDCAT JD6105D, Монтаж и эксплуатация

Страница: 41 / 252

ASSEMBLY
Assembly Section 2-9
CABLE CONTROL LEVER STAND
Place the cable control bracket on the floor so that the bracket is 4” from the front window.
Also the outer rear corner (heel) of the bracket is 5” from the edge of the door. The middle corner
of the bracket should be 2” from the edge of the door. See image below. Be sure that the loca-
tion of the stand will allow the operation of all control levers in the tractor and that the door will not
strike the stand when shut. Double check under the cab for cables and wires that may be cut
when drilling. And before drilling double check location of the stand for proper placement of
holes. Drill 3 holes to match control bracket and secure with capscrews and nylock nuts noted in
Parts Section.
The rubber boot under the rear window can be cut in a crosshair pattern and, if necessary,
the bottom cut through to allow it to slip over the cables and back into position. These cables will
be routed to the lift valve mounted on the valve mounting plate, and should not have any sharp
bends or kinks in them. Secure cables with zip ties and apply RTV sealer in and around individ-
ual cables, inside and outside of the cab for a water tight seal. Do not allow excess cable to
hang unsecured on the outside of the cab.
(ASM-JD-0239)
.