Tiger CNH T6010-80, Руководство по эксплуатации

Страница: 43 / 240

Assembly Section 2-11
ASSEMBLY
JOYSTICK MOUNT STAND
Mount the joystick stand mount in the same position as the cable control bracket.
Place the front edge of the support bracket 2 ¾” back from the lower right front
window. Rotate stand to be 2 ¼” from the right door frame as shown below. Be
sure that the location of the stand will allow clearance between the joystick and all
existing interior levers, etc.
Drill 3 holes to match control bracket and secure with cap-screws and nylock
nuts noted in parts section.
Cut a 2 ¼” hole in the floor from inside the cab. This hole is to be located 2 1/2”
away from the edge, and 4” from the metal edge by the right door. Install trim lock
around the metal edges of the hole, then route the cables through the hole. Next,
wrap the cables with the 6” split hose at the point they pass through the hole, and
secure with zip-ties.
LOAD SENSE HOSE ROUTING
The lift valve uses the Pressure, Return and Load Sense on the tractors rear remotes.
The ports used are directly under the valve mounting plate.
The pressure hose is routed from the tractor remotes to the inlet port of the HP Filter
on the valve mounting bracket. Then, the outlet port of the HP Filter to the pressure port
on the lift valve.
The return hose runs from the return port of the lift valve to the tractor remotes.
The load sense line is routed from the load sense port of the lift valve to the load
sense port on the tractor rear remotes.
For more information refer to the Parts Section pages for a complete diagram of the
tractor valve hookup.
LOAD SENSE
RETURN
PRESSURE