Project Serve Assembly Guide
Site Installation: Connecting The Appliance to The Power
9
Connecting The Appliance to The Power
Your Project Serve is shipped with two power supply modules, installed in the rear of
the appliance. These modules supply redundant power to Project Serve - should a
power supply module fail, you can replace it while the system is operating (see
“Replacing a Failed Power Module” on page 14). You can replace a failed power
module only with a power module of the same model.
To connect the appliance to the power supply:
1.
Plug the power cord in the power socket of the power supply module.
2.
Connect the power cord to the power outlet.
If the appliance is properly connected, the power module LED indicator will start
blinking in green. If there's problem with the module installation, its LED indicator
is red (blinking or solid) or there is no light at all.
Powering On The Appliance
To power on the appliance:
1.
Press once the power button
at the back of the appliance.
2.
Wait until the button (or the power status LED at the front) becomes solid green.
To turn off the appliance:
Important:
It is advisable to always attempt to shut down the appliance
through the web UI, before resorting to hard shut down.
Press continuously the power button
at the back of the appliance, until its light
goes off.
To restart the appliance:
It is advisable to always attempt to restart the appliance through the web UI,
before resorting to forced restart of the system.
Press the Reset button at the back of the appliance.
Connecting Project Serve to the Network
Important:
Before deploying Project Serve in your network, you must perform the
initial setup of the appliance from a computer, which is directly connected to the
Public port and using an IP address on the same subnet as the preset IP address of
