Project Serve Assembly Guide
Site Installation: Connecting Project Serve to the Network
12
1.
Remove the protective black cap from the 10GbE port.
2.
If your fibre optic cable has protective caps, remove them.
3.
Plug one end of the cable into the 10GbE port of the appliance.
4.
Do one of the following:
•
Plug other end of the cable in the 10GbE port of a client computer.
•
Plug other end of the cable in the 10GbE port of the Ethernet switch that is
connected to client computers.
Note:
If you opt for interconnection via switch, refer to your switch documentation
for further setup instructions.
To connect a computer to the Admin port:
Note:
The Admin port is designed as a safety net in case you misconfigure the
appliance’s network identification and fail to connect to it. For more details, refer to
“Project Serve Administration Guide“.
Important:
You cannot interconnect the appliance to the network using the Admin
port.
