Tiffin Motorhomes WAYFARER 2021, Руководство пользователя

Страница: 117 / 170

PLUMBING AND BATH FEATURES CONTINUED
RUN HOT AND COLD WATER FIXTURES FROM FRESH WATER TANK
After filling the fresh water tank, you are ready to run the water system from the fresh water
tank supply.
1. Turn "ON" the water pump. (Figure 10 9 .1).
2. On the sewer board turn the blue valve to the "DRY" position. (Figure 10 9 .2)
Figure 10 9 .1
Master Water Pump Switch
Figure 10 9 .2
To Use Water From the Fresh Water Tank, Turn
Blue Valve to "DRY"
SANITIZING HOT /COLD FIXTURES AND FRESH WATER TANK
To assure complete disinfecting of the fresh water system, it is recommended that the
following procedures be performed on a new system, one that has not been used for an
extended period of time or one that has been contaminated. This procedure is also
recommended before long periods of storage, such as the winter months:
• Drain the fresh water tank by opening the drain valve (Figure 10 9 .1). All of the faucets
should be in the closed position or "OFF" position.
• Prepare a chlorine solution using one gallon of water and one half cup of chlorine
bleach (5% sodium hypochlorite solution). Prepare enough of the chlorine solution to
administer one gallon of solution for every 15 gallons of water tank capacity.
Concentrations greater than 50 PPM s may damage the water lines and/or the water
tanks.
• Once the fresh water tank is empty, close the drain valves to the water tank.
• Pour the solution in the gravity fill which is located in the rear of the motorhome.
• Turn the water pump to "ON", on the sewer board turn the blue valve to "DRY".
• Open each faucet, in turning "ON" both the hot and cold faucets and flushing the toilet
until all of the air has been purged from the pipes and the water runs freely. The entire
system will then be filled with sanitizing solution.
109