Tiffany HC98, Руководство пользователя

Страница: 8 / 10

MAINTENANCE
1. Your clippers were carefully examined to ensure that the blades were oiled and aligned before leaving the
factory.
2. Blades must be realigned if they have been removed for cleaning or replacement.
3. To realign the blades, simply match the upper and bottom blades teeth up, point for point. (End fo top
blade teeth should be approximately 1.2mm back from bottom blade. Compare your clipper blades with
the sketch below.
4. If blade alignment is incorrect, add a few drops of oil to the blades, turn clipper on for a few moments, turn
off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned.
OIL
•
To keep Hair Clippers in peak condition, the blades should be oiled every few haircuts.
•
Do not use hair oil, grease, oil mixed with kerosene or any solvents. Solvents will evaporate and leave the
thick oil which may slow down the blades motion.
POWER SCREW
•
The power screw permits you to adjust the power. It has been adjusted before leaving the factory,
however if the voltage in your home is low, you may need to re-adjust it.
•
To adjust, use a screwdriver to the turn the power screw in a clockwise direction until the arm strikes the
coil - making noise. Then slowly turn power screw out (counter-clockwise) just until noise stops. This is
maximum power setting.