Tiernan TE3000, Инструкция по установке и эксплуатации, Страница: 68 / 114

58 Using a Remote Unit
MUX RED_STATE
2
Standby, Armed,
Triggered
Standby Sets the operating state of the spare encoder in a redundant system.
Parameters are:
!
Standby = spare encoder is in an inactive state and will not begin
operations in the event of a primary encoder failure
!
Armed = sets the spare encoder to begin operations in the event
that a primary encoder fails
!
Triggered = this state cannot be set; it is entered into automatically,
from the Armed state, when the loss of an external service is
detected.
Front panel command equivalent: Config>Tx Strm>Redund State
MUX RSR
2
— — Displays the name of the external service that has been replaced by
the redundant unit. Valid only in TRIGGERED state.
3
Front panel command equivalent: none
MUX SMPTE_EN On, Off Off Setting determines whether or not the SMPTE output is included in the
transport stream.
Front panel command equivalent: none
TAB ATSC_NAME <string> — Sets the ATSC name; up to 8 characters may be used.
Front panel command equivalent: none
TAB AUD_A_PID <#> where # is a valid PIDs 0 Sets the Audio A PID to be included in the output transport stream.
Zero is the default PID.
Front panel command equivalent: none
TAB AUD_B_PID <#> where # is a valid PIDs 0 Sets the Audio B PID to be included in the output transport stream.
Zero is the default PID.
Front panel command equivalent: none
TAB CARRIER_HZ 0-4294967295
in Hz
566310000 Hz Sets the carrier frequency when ATSC table types are enabled.
Front panel command equivalent: none
TAB MINORCH 1 to 99 2 Sets the minor channel in the ATSC tables.
Front panel command equivalent: Config>Service>Setup>Minor
Channel
TAB MAJORCH 1 to 99 30 Sets the major channel in the ATSC tables.
Front panel command equivalent: Config>Service>Setup>Major
Channel
TAB NIT_CC 1/1, 1/2, 2/3, 3/4, 5/6,
7/8
5/6 Sets the current FEC Convolution Code Rate entered in the NIT.
Front panel command equivalent: none
TAB NIT_MOD QPSK — Sets the NIT modulation type.
Front panel command equivalent: none
TAB NIT_NAME <string> MPEG-2
Encoder
Used to enter the network name; up to 115 characters may be used.
Front panel command equivalent: none
TAB NIT_NETID 0 to 65535 (decimal) 0 (zero) Used to enter the Network ID in the NIT.
Front panel command equivalent: none
TAB NIT_POL Hor, Vert, Left, Right Ver Sets the transmitted signal polarization. Parameters are:
!
Hor =linear-horizontal polarization
!
Ver = linear- vertical polarization
!
Left = circular-left polarization
!
Right = circular-right polarization
Front panel command equivalent: none
TAB NIT_SR ###.##### ###.##### — Sets the NIT transmitted symbol rate in sps.
Front panel command equivalent: none
TAB NIT_WSTFLG East, West West Sets the satellite orbital position. Parameters are:
!
East = satellite orbital position is East
!
West = satellite orbital position is West.
Front panel command equivalent: none
TE3000 Remote Command Descriptions
(continued)
Remote Command Parameter Range Factory
Default
Description