Settings
Set Defaults
Set Defaults
Note: Well pair the handset and cradle before starting to set the cradle.
Information Check
Firmware Version
Handset Serial No.
Cradle Serial No
Battery Power
Channel & Handset ID
Suffix Quick Setup
CR (Default)
LF
CR+LF
None
Setting the Data Upload Mode
There’re many preset options for data upload.
No Storing Mode:
Every code data will be uploaded instantly to the
cradle once well captured. In case of upload failure, the code data will
be ignored and alarm of “Beep-Beep-Beep” will come out.
Auto Storing Mode (Default):
The data will be stored in the handset
memory in case of upload failure to cradle. And the data will be
uploaded to cradle once the contact connection come back normal.
Manual Mode:
The code data will firstly be stored in the built-in
handset memory once well captured. It can store up to 10,000pcs code
data. The data would be uploaded to cradle in one time once the
Upload Start Code is manually scanned.
During the process of uploading or after upload well finished, if the
Upload Start
code is scanned, all code data stored in handset will be
uploaded again.
Auto Storing (Default)
No Storing
Manual Mode
Upload Start
(in Manual Mode)
Remark: In the Manual Mode, all stored code data will be kept until
manually erased. Every time the
Upload Start
code is scanned, all code
data stored in handset will be uploaded again. To avoid duplicating
upload data, please scan Erase Storage code to clear handset data.
Erase Storage
Insert Scanner ID before Barcode
In case two or more handsets are connected to the same cradle, the
handset ID can be inserted as prefix to each captured code in order to
identify the handset of capturing and uploading the single code.
Start inserting handset ID
Stop inserting handset ID (Default)
Caution: The handset ID is auto assigned by the cradles when pairing.
This handset ID can be set manually, but duplicated IDs are not allowed.
Setting Power of Wireless Communication
High (Default 16dBm)
Middle (8dBm)
Low (0dBm)
Caution: Please check with your local authority and set the power of
wireless communication according to local rules and regulations.
Setting the Volume of Beeper
High (Default)
Middle
Low
Mute
Prefix
Prefix On
Prefix (Default) Off
Start Prefix (0~16 chars, 2 digits/chars; 00~FF; 00*
）
Suffix
Suffix
（
Default
）
Do Not Transmit Suffix
Start Suffix (0~16 chars, 2 digits/chars; 00~FF; 0D*)
Parameter bar code
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Finish Setting
