Thyracont VD6, Руководство по эксплуатации

Страница: 40 / 52

40
man_vd6s2-de-130515
If no key is pressed for 5s or if changes are quitted by the menu key, changes
are discarded and the primary state is restored (undo function).
4.4 Start or Stop Control
When the VD6 display shows the actual pressure reading (measurement mode),
control can be started and stopped by means of the "set"-key:
Control on.
Active switching outputs are indicated
by the corresponding LEDs.
Control off.
4.5 Gas Correction Factors
For vacuum transducers whose pressure reading depends on type and composi-
tion of the gas a correction factor can be entered into the VD9 in order to adjust
the pressure reading. With this method a correct pressure reading is again
achieved then over a wide range.
The value for the gas correction factor can be found in the operation instructions
of the transducer or in suitable technical literature.
The range of the gas correction factor is 0,20 to 8,00.
In order to adjust the gas correction factor:
Press the menu key (several times), until the gas correction factor "c..." is shown
in the display.
Adjust the factor by means of the "Up" and "Down" keys.
Confirm with "Set" key.
If no key is pressed for 5s or if changes are quitted by the menu key, changes
are lost and the primary state is restored (undo function).
set
set
set