Page 2
For technical questions, please call 1-888-866-5797.
Item 68738
IMPORTANT SAFETY
INFORMATION
In this manual, on the labeling, and all other
information provided with this product:
This is the safety alert symbol. It is
used to alert you to potential personal
injury hazards. Obey all safety
messages that follow this symbol
to avoid possible injury or death.
DANGER indicates a hazardous situation which, if
not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if
not avoided, could result in death or serious injury.
CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
NOTICE is used to address practices
not related to personal injury.
CAUTION, without the safety alert symbol, is used to
address practices not related to personal injury.
WARNING Read all safety warnings and
instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions for
future reference.
The warnings, precautions,
and instructions discussed in this instruction
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
Installation Precautions
1.
Exercise special caution if working on roof
or another high location.
Keep proper footing
and balance at all times. Follow ladder supplier’s
precautions whenever working near or on a ladder.
2.
Install all sensitive electrical components
(including wiring connections, regulator,
and battery) inside a weatherproof
enclosure to prevent electric shock.
3.
Do not wire multiple panels in series.
If you
need to connect two or more solar panels together,
this work must be done by a qualified electrician
unless they are connected through a regulator.
4. This solar panel kit is not designed for tie-in to a
grid. Only a licensed electrician and a licensed
building contractor can safely design and implement
a grid tie-in system. Any grid tie-in system must
meet all applicable building and electrical codes,
and must meet standards established by the area
power company. Improper grid tie-in can result in
electrocution, fire, and other serious personal injury
and property damage. An incorrectly installed grid
tie-in system can cause feedback voltage, resulting
in electrocution of electrical utility workers.
5.
Do not stand on or otherwise
apply pressure to panel.
6.
Handle solar panel with care,
edges may be sharp.
7.
Do not focus light on panel.
8.
Install components with enough
space to allow proper cooling.
9.
This product may occasionally produce more
current and/or voltage than its rated output.
Increase output ratings by 25% when determining
component required voltage and amperage
ratings.
Refer to Section 690-8 of the National
Electrical Code for an additional multiplying factor of
125 percent (80 percent derating) which may apply.
