Thunder 4001J, Руководство пользователя

Страница: 11 / 20

11
PREPARATION AND ASSEMBLY
1. After unpacking the product, inspect carefully for any damage that may have
occurred during transit. Make sure to tighten fittings, bolts, etc., before put-
ting unit into service. Tighten the gun to the cup securely using the connector
with filter inside.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer’s
instructions. Most materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Tighten the gun to the cup securely using the connector with filter inside.
5. Fill the cup about 3/4 full and start the air compressor.
6. Set up a piece of cardboard or other scrap material to use as a target and
adjust for best spray pattern.
7. Test the consistency of the material by making a few strokes on a cardboard
target. If material still appears too thick, add a small amount of thinner. THIN
WITH CARE! Do not exceed paint manufacturer’s thinning recommendations.
DO NOT EXCEED Maximum Pressure of Spray Gun
or any other parts in the compressor system.
Maximum pressure is 120 PSI.
Consult with the paint
manufacturer for recommended air pressure.