Thunder 4001J, Руководство пользователя

Страница: 18 / 20

18
Possible Causes Likely Solutions
Sputtering Spray 1. Low paint level.
2. Cup tipped.
3. Clogged Air Vent on Cup.
4. Loose Fluid Inlet connection.
5. Loose/damaged Fluid Tip/Seat.
1. Refill.
2. Hold upright.
3. Clean Air Vent hole.
4. Tighten Fluid Inlet connection.
5. Adjust or replace Fluid Tip
and Fluid Needle.
Will Not Spray 1. High air pressure.
2. Fluid Knob not open enough.
3. Pattern Knob open too far.
1. Check air hoses.
2. Open Fluid Knob.
3. Thin fluid or increase air
pressure.
(Do not exceed maximum.)
Overspray
(Paint drifting to
unintended
objects.)
1. Improper application speed.
2. Improper distance from
workpiece.
3. Too much air pressure. 1. Move moderately and parallel.
2. Adjust distance.
3. Reduce air pressure.
Fluid Tip Leakage 1. Dirty Fluid Tip.
2. Broken Fluid Needle Spring.
3. Worn or damaged Fluid Tip. 1. Use a nonmetallic point to clean
Fluid Tip.
2. Replace Fluid Needle Spring.
3. Replace Fluid Tip and Fluid
Needle..
Air Leaking from
Nozzle 1. Dirty Air Valve/Seat.
2. Sticking Air Valve.
3. Damaged Air Valve Spring.
4. Worn/damaged Air Valve/Seat.
5. Bent Air Valve Stem. 1. Clean Air Valve/Seat.
2. Lubricate Air Valve/Seat.
3. Replace Air Valve Spring.
4. Replace Air Valve assembly.
5. Replace Air Valve Stem.t.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
General Troubleshooting Chart