THUNDER TIGER TOMAHAWK XL, Инструкция по эксплуатации и каталог запасных частей

Страница: 5 / 27

1
CHARGING THE GLOW PLUG IGNITER
電夾充電方式
Glow plug igniter and charger has to be purchased separately.
充電電夾需另外選購
a b c
a. Use the supplied wrench to install all 4 tires/wheels.
b. Apply the supplied wheel nuts onto the hex adapter.
c. Turn the wrench to tighten the wheel nuts.
a.
將輪胎裝入六角輪座。
b. 鎖上六角螺帽。
c. 用內附的扳手鎖緊螺帽。
2
INSTALLING TIRES
輪胎安裝
b
a
c
4
a. Plug the charger into an AC outlet, and then pull on the igniter lever to accept the charging adapter.
b. At this point, the small red LED indicator on the charger should light up indicating the charging sequence is in progress.
c. When the charging complete, pull on the glow plug igniter lever to unplug the glow igniter. Charge the new glow plug
igniterfor 16 to 24 hours on the first charge. For subsequent charges, charge it about 12 hours before next use.
Note ! If the igniter gets warm or hot during the charge, unplug the igniter from charger immediately. A warm / hot
igniter means the igniter is overcharged. Overcharging can damage the internal battery in the igniter; thus,
shortening its life.
a.
將充電器插入家用
110V
插座中，再接上電夾。
b. 充電過程中，紅色 LED 燈會保持亮的狀態，如不亮表示為短路，電池無法充電。
c. 充電完成，將充電器自插座拔下，再分開電夾；新電夾首次充電時間需 16 到 20 小時，之後只需充大約 12 小時即可。
注意！充電過程中，電夾電池如出現高溫現象 (40~45°C) ，表示已過度充電，需立即停止充電。過度充電容易造成電池損
壞，更可能產生爆炸起火，請謹慎使用。
b
a. Install 8 AA size alkaline batteries into transmitter.
b. Connect receiver battery with the switch.
c. Install the battery into the receiver box, secure the box with a body clip
.
a.
安裝 8 顆 3 號電池於發射機上，請注意正負極正確安裝方向。
b.
連接接收機電源線、開關線。
c.
將接收機電池安裝於接收盒中並使用
R
型插銷固定。
RADIO BATTERY INSTALLATION 遙控器電池安裝
c
3
a