THUNDER LASER
MINI-60
www.thunderlaser.com
THUNDERLASER TECH CO., LTD
Tel :(86)755 82689501
74
Chapter 6 The Characteristics of Thunder Laser
1.1 Laser heads for application
------------------------------------------------------------------------------------------------------------------------------
Different laser head owns different focal distance and laser dot size, thus they were used
for different job.
According to customer’s application, we have three kinds of laser head for choice.
TYPE
LASER DOT SIZE
FOCAL
DISTANCE
FUNCTION
Standard head
0.0039''(0.099mm)
5.0mm~6.5mm
For common cutting and engraving
HR head
0.0020''(0.050mm)
3.0mm~4.0mm
For engraving high quality picture and
cutting very thin material
4” laser head
0.0078''(0.198mm)
9.0mm~11mm
For cutting thick material
Note 1: Standard head means 2” head; usually we use it for cutting material less than
10mm thickness and engraving simple patterns.
Note 2: HR head is special for engraving high quality picture and cutting very thin
(usually less than 1mm) material for getting a precise job.
Note 3: 4” laser head is special for cutting thick material (usually more than 10mm).
Usually we install a 2” standard head for our Thunder Laser system, and HR
head and 4” head are optional parts,
You can choose them according to your job requirement.
----------------------------------------------------------------------------------------------------------------------
Below are detail descriptions for
HR head and 4” head.
----------------------------------------------------------------------------------------------------------------------
HR head
High Resolution head, HR head for short which was made by special structure, this
structure allows laser beam to be focused into a much smaller focal dot,
and it is
suitable
for intricate, tight-tolerance engraving and for direct marking on some metals
