AMPLIFIED THUNDERFORM
Routing Power Wire; we recommend a connection directly to the battery.
5.
Starting at the rear of vehicle, remove plastic trim on drivers' side.
6.
Using furnished wiring harness route 10ga red power wire starting at pre-amp
location. Route wire on drivers' side over to threshold and under carpet to the
front of vehicle.
7.
Open hood.
8.
Drill a hole through the fire wall. Locate a spot low on the fire wall on the
passengers' side. You should always look to find a clear path. Drill a hole from
inside of the vehicle into the engine compartment and insert grommet. You may
also find a pre-existing, unused rubber grommet in this location that you can pass
the wire through.
Note: To avoid any damage to parts inside engine compartment, drill from
inside of vehicle using a short bit.
9.
Route 10ga red power wire through a grommet into the engine compartment.
10.
Route 10ga red power wire through engine compartment safely away from
any moving or hot parts that could damage the wire.
11.
Cut 10ga red power wire to length, connect the supplied fuse holder from the
wire kit to the end of the wire.
12.
Remove 20amp fuse from MTX fuse holder. Connect furnished ring terminal
to positive side of battery. Remove 5/16" nut from factory battery terminal. Place
ring terminal on battery post and retighten nut.
20.
Reinstall threshold trim. Locate and align holes in vehicle with pins on trim;
and snap back into place.
21.
Lift enclosure into your vehicle and place it on the floor behind the seat with
the woofer facing toward the passengers' side of the vehicle. Mount the enclosure
to the floor and upper bracket with included screws.
22.
Replace floor mat, sliding it under your new enclosure.
23. If externally amplified, make speaker connections to the enclosure from
the amplifier. Connect speaker wires from amplifier to enclosure, positive to red
terminal and negative to black terminal.
2
5
