Thumpstar TSE12, Руководство пользователя

Страница: 35 / 53

32
Repair and Maintenance
After you have removed the slack out of the wire, and pulled the charge
wire out of the hole, you can push the battery in all the way. Put your 2
thumbs on top of the battery and push the battery inside (see pic below).
Be careful not to push the battery in too far because you will pinch the 2
sets of wires coming out of the hole near the handle bars side (12in only)
however it needs to go in far enough so the controller can fit in.
Step four:
Put the controller back in the box, backside first (no wires side)
goes in first. If you disconnected the motor wire plug it in first (don’t forget
to align the arrows and push hard), lay the large black wire on the right
side as shown in the pic below, make sure all the wires go under the large
black wire or the black wire wraps around the outside of all the wires. They
should look like the pic below. Lay the wires to the left side so that they are
not all bunched up in the center (they will push on the switch and cause
damage) and the larger wire for the motor will lie on the right side, as you
are looking from the back (see pic below). Plug in the throttle wire, power
switch, and brake switch (the wires that come from the handlebars and
you put it next to the battery, see diagram on the last page for wire color
reference) and tuck the connectors in the front between the battery and
controller.