THOR TH-SSM, Инструкция по эксплуатации

Страница: 81 / 148

THOR-SSM
Rev. : 02/09/2012
81
For communication please set up the format of the serial data communication to:
115.2K, 8, 1, NO
(115.2 KBAUD, 8 Data bit, 1 Stop bit, NO parity)
Control commands
In the ‘Crosspoint- Switch’ operating mode the following control commands are allowed:
•
STX, 0x40, 0x80, ETX Acknowledgement of the system info
•
STX, 0x45, ETX
Reset on factory settings
•
STX, 0x54, ETX Reset the Crosspoint- Switch
•
STX, 0x47, <Rem-No>, <Loc-Nr>, ETX
S
witch a single (remote-)output to
a (local-) input
•
STX, 0x48, <Rem-No>, ETX
S
witch off a single (remote-)output
•
STX, 0x52, ETX
Switch off all local-/ remote-connections
•
STX, 0x66, 0x80, <Macro-No>, ETX
S
ave switching status to macro
•
STX, 0x67, 0x80, <Macro-No>, ETX
L
oad switching status from macro
where:
<Rem-No> 7Bit date 1 to 7
<Loc-No> 7Bit date 1 to 7
<Macro-No> 7Bit date 1 to 8
Examples:
STX, 0x54, ETX Reset the switch and set the connections as a function of
SW7 (see above)
STX, 0x40, 0x80, ETX Read the system info (version number) from the switch
STX, 0x52, ETX
S
witch off all local-/ remote- connections
STX, 0x47, 0x84, 0x81, ETX Switch (remote-)output 04 to (local-)input 01
STX, 0x47, 0x85, 0x81, ETX Switch (remote-)output 05 to (local-)input 01 ((remote-)
output 04 and 05 show the same picture now!)
STX, 0x47, 0x86, 0x81, ETX Switch (remote-)output 06 to (local-)input 01 ((remote-)
output 04 - 06 show the same picture now!)
STX, 0x47, 0x87, 0x81, ETX Switch (remote-)output 07 to (local-)input 01 ((remote-)
output 04 - 07 show the same picture now!)
STX, 0x66, 0x80, 0x81, ETX Saves active switching status as macro 1
STX, 0x52, ETX Opens all connections (all monitors are without picture)
STX, 0x67, 0x80, 0x81, ETX Call macro 1: (remote-)output 04 - 07 show the same
picture of (local-)input 01 now
STX, 0x48, 0x84, ETX Open the connection between (remote-)output 04 and the
equivalent (local-)input (only monitor 05 – 07 show the
picture)