THOR-SSM
Rev. : 02/09/2012
57
6. Service Setup
6.1 THOR Small Switch for CATx
Normally, it is only necessary to make adjustments during installation.
In order to make these adjustments, you do not have to open the THOR Small Switch. All
settings can be made from the outside using the Operating Mode Selector (DIP switch).
By selecting a new operating mode, the allocation of inputs
and outputs may be changed. In doing so, it is possible to
interconnect two transmitters: this may damage the
connected equipment.
The location of the operating mode selector (DIP switch) is shown below:
For the selection of a new operating mode:
1.
Switch off the THOR Small Switch.
2.
Select a new operating mode according to following table.
By selecting a new operating mode, the allocation of inputs
and outputs may be changed. In doing so, it is possible to
interconnect two transmitters: this may damage the
connected equipment.
3.
Power up the device.
Operating Mode
Selector
Содержание TH-SSM
