December 14th 2018
www.thonk.co.uk
10
PROK DRUMS
Eurorack DIY Kit
Instructions
Version 1
21.
Next take the long male pin
header and break it into 3
different lengths:
1 x 14 pin length
1 x 13 pin length
1 x 2 pin length
If you are using side cutters to do
this be sure to wear safety
goggles.
22.
Now place the male pins into the
Teensy as shown, then carefully
solder the pins.
Make sure the pins are soldered
flush and perpendicular to the
PCB surface.
23.
Next take the three 20 pin female
headers and cut them to the
following lengths:
1 x 14 pin length
1 x 13 pin length
1 x 2 pin length
1 x 11 pin length
1 x 7 pin length
Be careful when cutting these
down – it’s better to cut too large
and then trim down, rather than
cut too small and be left with a
useless length.
Be sure to wear safety goggles when
cutting these headers.
14 PIN
13 PIN
2 PIN
