InTRoDUcTIon
P3
En
g
lis
h
•
It is a necessity that you only use an approved extension and compatible wiring that is suitable for the
electrical power consumption of the installed equipment. Please ensure that the electrical power supply
corresponds with the voltage on the electrical identification plate at the back of the receiver.
If the receiver does not operate normally, even after strictly following the instructions in this user manual it
is recommended to consult your dealer or the appropriate service for your country.
1.2 Storage
Your receiver and its accessories are stored and delivered in a packaging designed to protect against
electric shocks and moisture. When unpacking it, make sure that all the parts are included and keep the
packaging away from children. When transporting the receiver from one place to another or if you are
returning it under warranty conditions, make sure to repack the receiver in its original packaging with its
accessories. Failing to comply with such packaging procedures could damage the product and void your
warranty.
1.3 equipment Set-up
We recommend you to consult a professional installer to set up your equipment. Otherwise, please follow
the instructions below:
•
Refer to the user manual of your TV and your antenna.
•
Make sure that the HDMI cable and outdoor components are in a good condition and the HDMI
connections are well shielded and from good quality.
This user manual provides complete instructions for installing and using this receiver. The symbols serve as
follows.
waRnInG
:
Indicates warning information.
noTe
:
Indicates any other additional important or helpful information.
menU
Represents a button on the remote control or the receiver.
(bold characters)
Move
to
Represents a menu item within a screen.
(
Italic
characters)
1.4 accessories
•
1x user manual
•
1x remote control unit
•
2x 3 V Lithium CR2032 batteries
•
1x adapter 12 Volt DC, 2 Ampere
•
1x HD+ smart card
1.5 Usage of external USb devices
•
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specifications, recording and playback with your receiver might not work properly.
•
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power specifications
might exceed the supported output of your receiver (5V/500 mA). If so, please connect your USB HDD to
an according external power adapter.
•
THOMSON cannot guarantee compatibility with all types of USB storage devices.
•
It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. THOMSON will not
take responsibility for any loss of information or circumstances caused by loss of information.
•
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB device
via your receiver. Formatting requires entering the PIN code (default ‘0000’)
•
THOMSON cannot guarantee the playback of all files although extensions are listed, as it depends on file
size, codec, bit rate and resolution.