10
Adjusting the Tension of the Door Spring
The dishwasher door is attached to springs.
They are set at the factory to ensure that
they are at the proper tension, so that the
door can be opened and closed smoothly.
After the furniture door has been fitted, you will need to adjust the tension of the door
spring.
Use an Allen key (not supplied) to rotate the adjusting screw or either tighten or loosen
the steel cable.
The spring tension is correct when:
a) The door remains horizontal in the fully opened position.
b) You are able to close the door easily.
WARNING:
If the tension of the door spring is not adjusted, then it could cause damage to
the appliance.
Connecting to the Mains Water Supply
Inlet hose (Cold water supply)
The water inlet hose from the machine terminates in a 3/4" female
connector. The water supply should therefore terminate in a similar
male connector and should have a stopcock close by in the pipe.
Connect the straight connector of the inlet hose to the water supply
securely ensuring that the washers are securely in place at both
ends of the hose.
Water Pressure
For best operating results, incoming water pressure should be between 0.04 MPa and
the household water pressure is low, dishwasher fill time will increase or may not operate.
WARNING
: Please close the hydrant after using.
Downloaded from www.vandenborre.be
