THOMSON LDK 20 S, Руководство оператора

Страница: 18 / 60

3-2 Operator's Manual LDK 20(S) - Studio Camera) Configurations
Basic Configurations
Stand-alone mode
The LDK 20(S) is a studio camera that can be used in
various configurations. The first configuration is the
stand-alone mode where the camera is connected to
a separate VTR. The LDK 20(S) camera is delivered
ready to operate in the remote mode. If the camera
has been switched to the local (stand-alone) mode,
follow the instructions to switch it back to the remote
mode in Section 2 of the installation manual. The
power supply is now provided to the camera via the
mains AC power supply at the right side of the
camera. The VTR is connected to the 26-pole connector on the rear of the camera by means of the
optional VTR cable LDL 2110. The camera connector
provides SMPTE/EBU video component signals for
the VTR. The playback signal from the VTR can be
monitored in the viewfinder. The camera controls are
all operated locally on the camera or via a single OCP/
MCP connected to the data connector.
It is also possible to connect a VTR to the camera
when it is operating in the Triax (Remote) mode for
parallel recording. In this case power is supplied via
the Triax cable.
Power
Supply
26-pole Recorder Cable
Maximum Length
10 m (33 ft)
VTR
Mains
AC Power
Supply
OCP
LDK 4629
LDK 20(S)
Data Cable
Maximum Length
350 m (1150 ft)
HiRes
Digital
Mains
AC Power
Supply